Residential Plumbing Systems

In most homes, a single Aqua-Rex^® WK1 installed on the cold water main will provide adequate scale protection.

Location

The best place to fit an Aqua-Rex^® unit is near the water heater. Install it as close as you can to the water heater and place on the cold water supply pipe.
The signal generated by Aqua-Rex^® treats the water irrespective of whether the water is flowing or static. It travels both upstream and downstream through the water and pipes, which means water does not have to flow through the Aqua-Rex^® unit for it to be treated.

Central Heating Systems

The central heating system operates on a closed circuit and should not normally suffer from scaling. It does not need a separate unit but will benefit from signal transfer at the heat exchanger.

Very Easy to Install

Installation simply requires a power source near the spot where the unit will be located. Simply wrap the entennas around the supply line as indicated in the installation instructions included. Plug in the unit, and thats it. An extension cord may be used if necessary.

Maintanance

The Aqua-Rex^® unit needs no maintenance or servicing. Occasionally inspect to insure the lights are flashing. If the Aqua-Rex^® stops working, first check the power source. If the transformer is cold, that means it has failed. Please contact us for instructions or warranty issues.